Tweet
Running 3.7MR2 writting an iterative align to cad with loop runs the loop but wont write to program any help appreciated.
-
sigpic
3.7 MR4 -
I am not the "loop king" now that I have made 2 programs that loop, but, can you explain a little more in depth what you mean by "won't write to program"?
Have you seen this?
GO HERELast edited by JamesMannes; 05-19-2007, 04:12 PM.sigpic
James Mannes -
James thanks anyways but would run the loop but wouldn't put it in the program so I wrote it with out the loop command saved program went back in edited and added loop to program works ok now? must of just been SATURDAY.sigpic
3.7 MR4Comment
-
I have searched with no luck for an answer. I am very new to looping and have some questions. Right now, I am doing a Man align then loop commands then...11-04-2015, 03:58 PM -
So I have 16 parts I need to measure in a 4 rows of 4 pattern. It's a simple 5 hole bolt pattern concentric to the I.D. Plane on the flange and level...10-10-2014, 07:10 AM
-
I finished my first loop program, i want to know how to use the "Subroutines".
...11-18-2014, 05:29 PM -
Good morning all I hope you are all having a good day, I have a program that contains a simple loop to check multiple pockets on a valve rotator body,...01-13-2017, 05:37 AM
-
I was asked a question but one of our new inspectors when we were discussing looping. Say you have five parts you want to setup and measures all five....09-15-2016, 04:37 PM
Comment