Increase execution speed

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Increase execution speed

    I have a relatively large program and am having an offline issue with a simultaneous evaluation. This requires me to keep running the program to test. Unfortunately, running the program runs a whole simulation/animation. I have increased the animation speed to an absurdly high rate but it still takes about 35 seconds to run.

    Is there a way to run the program without sitting through the animation?

  • #2
    Mini routine of just the relevant dimensions?

    Comment


    • #3
      Really!?!?!?!? 35 seconds is to long?
      (In Memory of my Loving wife, "Ronda" who I lost March 7, 2016. I love you baby.)
      They say "Nobody's Perfect." I must be Nobody.

      Comment


      • #4
        Took you longer just to type this question up
        (In Memory of my Loving wife, "Ronda" who I lost March 7, 2016. I love you baby.)
        They say "Nobody's Perfect." I must be Nobody.

        Comment


        • #5
          KIRBSTER269 35 seconds is too long when I am running it after each subtle change. I am spending more time waiting than I am making changes. It is not an unrealistic question.

          Thanks kingsld1 I may give that a shot.

          Comment

          Related Topics

          Collapse

          • gsepan
            Machine Speed
            by gsepan
            Hope this isn't a stupid question but...

            How fast do you folks run your machine? I know certain machines can move faster then others so...
            06-30-2006, 11:37 AM
          • Addison Wood
            V4.3MR1 Offline Execution Speed
            by Addison Wood
            I was told by Hexagon that in V4.3MR1 the problem with offline execution speed would be fixed i.e. probe MOVESPEED and TOUCHSPEED would be able to be...
            03-31-2009, 01:08 PM
          • eric_451@hotmail.com
            Slow Machine
            by [email protected]
            !Yet another newbie question!
            We just updated to v.4.2. Since that time my machine has been moving much slower than it was. Is there a speed setting...
            10-02-2007, 03:49 PM
          • Master Chief
            Touch speed
            by Master Chief
            Have a question with touch speed. If I slow down my touch speed in the middle of a program (to measure a couple of fairly small holes) would this affect...
            02-04-2009, 11:44 AM
          • Darrollh
            Simulation Speed
            by Darrollh
            Good morning everyone,
            I am using 2015.1 off-line. How do I slow down the probe movements during simulation. I set the speed to 10 but it still...
            02-01-2017, 09:12 AM
          Working...
          X