Error message

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Error message

    I have a Mistral running 4.1, and am getting the following error message, 'LEVEL3: AXIS Z ERROR(0xe)'
    The probe is moving down the table length and will veer off to the right (without touching anything) and crash the system. This happens in Manual and under programme conditions.
    has anyone experienced this sort of thing or know what the error code means?

    Thanks
    Tags: None
  • #2
    check the encoders and scales
    Kevin

    Comment

    Previous template Next

    Related Topics

    Collapse
    • Tested
      Error message
      by Tested
      Has anyone seen or heard of this Error before. I did a edit on a long time running program and now before it starts it gives this error.'
      ...
      12-11-2007, 08:14 AM
    • JVau425033
      Error message
      by JVau425033
      Can some one tell me what this error code is??...
      06-17-2014, 02:15 PM
    • Guest's Avatar
      Error Message
      by Guest
      Has any one seen this Error message? If so what is going on? B&S ONE with PcDmis 3.7...
      11-27-2007, 10:40 AM
    • Guest's Avatar
      ERROR message
      by Guest
      Hi all,
      I have a problem. When using the probe changer the probe stops in the middle of the probe change and I get this error message (TR_FG107,...
      10-09-2006, 12:39 PM
    • wsneeden
      Error in connect=0 message
      by wsneeden
      I am wondering if anyone has ever encountered this error message before....

      When opening PCDMIS I receive an error message of 'error in...
      06-03-2015, 09:34 AM
    Working...
    X