Pc_dmis 2020 r2 build#186_ feature / cad compensation

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pc_dmis 2020 r2 build#186_ feature / cad compensation

    Trying out R2 again today. Created new program, Imported CAD (SW 2020), built probe, calibrated, manual program mode, began clicking to create manual alignment features. Noticed the line I created is not compensated / attached to the CAD. It appears at the center of the probe.



    ************FIGURED IT OUT. SOLUTION INVOLVED THE USE OF GLASSES.....


    FEATURE OFFSET-2.PNG
    Last edited by Benedictj1; 09-25-2020, 04:09 PM.
    sigpicTAU ALPHA PI INDIANA DELTA CHAPTER
    "Due to the highly confidential nature of my job, I am not allowed to know what I am doing" - author unknown

Related Topics

Collapse

Working...
X