Manual Hit Retract

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Manual Hit Retract

    I am setting up a machine with a new computer and software. It's a global silver advantage, and the software is 2019. My manual hit retract isn't working ( or isn't set right ) and when the probe is contacting the sphere during the calibration routine, it dwells. I keep hearing about this FDC interface. How do I find it, and how do I set my manual hit retract values?

    Thanks.

  • #2
    There should be a shortcut on the PC desktop. You can also just open a web browser and type the IP address of the controller in as the URL. For an FDC it is 100.0.0.1
    Neil Challinor
    PC-DMIS Product Owner

    T: +44 870 446 2667 (Hexagon UK office)
    E: [email protected]

    Comment


    • #3
      Thanks,

      I'll try that.

      Comment

      Related Topics

      Collapse

      • gablega
        Manual Hit
        by gablega
        Is it possible to take a manual hit while running Inspect? We have parts that get welded and sometimes require a manual hit because of the extra material....
        03-18-2021, 08:41 AM
      • in search of zero
        manual probe retract
        by in search of zero
        Hello
        Version 4.1, Sheffield Summit CMM
        Does anyone know how to get around this?
        If I take a MANUAL hit on a surface with a TP7...
        02-19-2008, 07:32 AM
      • ScottP815
        New user
        by ScottP815
        So this is probably a pretty dumb question but here goes. I have version 2020 R1. I am trying to get my probe retracted to change. So I went into the...
        12-18-2020, 10:41 AM
      • gcunniff
        2012 Manual Hits Prehit/Retract Problem
        by gcunniff
        Running an iterative alignment using several 7mm x 13mm slots. I have the Prehit and Retract set to 2mm, but during the manual point selection process,...
        02-19-2013, 07:31 AM
      • Ken8282
        Probe actiing strange
        by Ken8282
        After I take a manual hit with the probe it moves in the Z minus and Y minus. It has never done this till today. The probe does not drift when left alone....
        05-09-2013, 11:18 AM
      Working...
      X