Report Window not populating after end of program.

[Paul Sarrach]

We did a reinstall Ver 2019 R2 and the Report Window not populating after end of program.

Any suggestions?

[bfire85]

Silly question...do you have dimensions?

Do you have the standard reporting from Hexagon or use custom reports?

[Matthew D. Hoedeman]

dims set to STATS only or NONE

[JEFMAN]

Check "report only OOT" in F5, and something like "update report during execution.

[Cumofo]

You need to toggle "view report mode" on the left, vs the default "View Last Execute Report Mode" near the center console. veiw report mode.jpg

[JEFMAN]

Or use "update"...
In this case, "View Last Execute Report Mode" should display something...

[Paul Sarrach]

Silly question...do you have dimensions?

Do you have the standard reporting from Hexagon or use custom reports?

Yes, dimensions.

Yes, using standard legacy reporting.

[Paul Sarrach]

dims set to STATS only or NONE

No Matt, checked that too. Nothing changed from what I can see. It is still sending stats to Datapage,. It sends a blank sheet to file. And all I have to do is hit refresh and it appears and hit print again and overwrite the blank page. WTF

[Paul Sarrach]

Check "report only OOT" in F5, and something like "update report during execution.

Both are fine. Thanks

[Paul Sarrach]

You need to toggle "view report mode" on the left, vs the default "View Last Execute Report Mode" near the center console. veiw report mode.jpg

Will try that on next part. Not sure I will get that until we come back from COVID VIRUS SHUTDOWN. But thanks