True Position Feature Set

[Bob Pierce]

Is it legitimate to dimension true position to a feature set?
I have a print where the true position call out is to 3 adjacent sides of a cube.

[rangerboat72]

Hmmm, I've never seen that before. Could you upload an image of the drawing to clarify your question?

[Cumofo]

Is this similar to a dual reference frame?

[Bob Pierce]

I am working on a method to show the drawing.

[Bob Pierce]

Using version 4.1
Feature sets, lines nor planes appear in the choice of features that may be dimensioned as true position, so I am going to assume the Engineer is a bit off base.

[rangerboat72]

Using version 4.1
Feature sets, lines nor planes appear in the choice of features that may be dimensioned as true position, so I am going to assume the Engineer is a bit off base.

You know what they say about the word ASSume...

[Bob Pierce]

oh I am with ya and it is impossible to convince some engineers there is a better way.