Tweet
I'm trying to understand the true position in which datum shifts are called out and the Datum B & C are controlled by profile of surface. Can any one explain how to construct feature control frame in pC-Dmis.
-
-
Shyte! This one was a tough one for me... I use Legacy not xact. The shift was about one Datum. I basically had to shift it around within it's allotted shift with variables to then an alignment, was fun. I reported out the shift along with dimension callout.PcDmis 2015.1 SP10 CAD++
Global 7-10-7 DC800S -
Is B datum a diameter? or a midplane between two planes?Comment
-
-
I have measured a profile and reported using XactMeasure. My profile is only constrained to a plane and therefore fixes 3 degrees of freedom in the datum...03-18-2015, 06:06 PM
-
For a long time I ignored the Datum Shift table on my report because I didn't really understand it. Lately I thought I understood, but then I started...03-22-2016, 08:36 AM
-
hey all,
i know what is Datum shift segment when True Position call out in XactMeasure, This is used to show the reader how much datum shift...10-24-2017, 06:29 PM -
Please help me.
I have a profile call like as ' surface profile 0.02|B|C|' . And the arrow is pointing datum A. What does that mean?. I don't understand...11-23-2017, 08:59 PM -
I am having an odd issue trying to create a profile dimension. I have attached a PDF of a mockup drawing that is the same layout as my part.
...06-29-2020, 12:40 PM
Comment