2019R2 Summary Mode While running program

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mlombardo157
    replied
    I have a different question when working in V19R2, I prefer working in summary mode. However, it does not allow the drop down folder when looking at a feature to see the theo / actual / target as in previous PCDIMS versions. I have to go into command mode to view those. Is there a setting for this?

    Leave a comment:


  • gszpot
    commented on 's reply
    Thanks AndersI. I hit F5 and checked the "Use Program Layout for Execution"

  • AndersI
    replied
    Start a program with some manual measurement. Instead of measuring you adjust everything until it looks as you want it. Stop the program *and save it*. You have now adjusted the secret special window layout used when executing.

    Or, F5, General tab, locate "Use Program Layout for Execution" and make sure it is checked.

    Leave a comment:


  • gszpot
    started a topic 2019R2 Summary Mode While running program

    2019R2 Summary Mode While running program

    I have installed PcDmis 2019R2 on 4 of our machines. Now the edit window goes into summary mode while running a program. I want it to stay in command mode. We just installed a new machine with 2019R2 and it stays in command mode. Can someone tell me where I can change this setting?

Related Topics

Collapse

  • johnP
    New job... new problems
    by johnP
    I am having a problem with 1 machine with 2010 loaded. While programming and executing, the edit window changes from command mode to summary mode by itself...
    10-13-2011, 06:01 PM
  • Carlos Lumbre
    Command Mode
    by Carlos Lumbre
    Some body can help me , my program in Command Mode when start to run(execute) change to Summary Mode. I try go to View/Command Mode but return to summary...
    05-10-2019, 07:23 AM
  • Jay Curtis
    Desktop Configuration
    by Jay Curtis
    On my desktop configuration, I have the edit window in "command mode". The problem I'm having is when I press "control Q" to execute...
    10-29-2020, 06:32 AM
  • mtjohn
    Edit window change
    by mtjohn
    Just installed PC-DMIS 2017 R2. The edit window changes from command mode to summary mode when executing a program.
    05-08-2018, 08:25 AM
  • bsteele
    Summary / Command mode
    by bsteele
    Looking for some help here. Since we updated to 2017 R2, When executing programs, the edit window switches to Summary mode and will not let us change...
    05-16-2018, 10:32 AM
Working...
X