Tweet
New to programming, I created manual and dcc alignment, then had to measure points on an inside cone. When I went to run program it ran thru dcc alignment then "skipped" over my measured points. What am I doing wrong.
-
Last edited by RRyan; 12-03-2019, 03:32 PM. -
Post your code
sigpicHave a homebrew
-
I have a simple program to measure the notch steps in a car key. I do a manual alignment to locate the part in a fixture made using a universal fixturing...08-20-2014, 02:11 PM
-
Hi Everyone,
I am a new user to CMM and pc-dmis program and I have a question which I cannot solve on my own.
I am trying to...04-19-2008, 11:15 AM -
I am not using CAD....
When I "program", I usually take 3 features and insert an alignment using these, and go into DCC mode.
...10-07-2008, 10:06 AM -
I normally do an iterative alignment when programming
I am running some older programs that I did not program
these are machined...02-14-2008, 09:28 AM -
Here's one for ya. I write a program at my off line seat. I have a manual alignment and a DCC alignment. I simply copy the points for the manual alignment...10-04-2013, 11:04 PM
Comment