problem whith PC-dmis!

[Hash2006]

I have a problem with a program made by me in the PC-Dmis program, this error consists in the fact that at the end of the program, cmm executes a move that I do not have at the end of the program, I want to mention that this happens from time to time .
For example today I measured three part and in the third one there was the movement that led to the collision.Pease help me with an answer. Thank you

[Darrollh]

Check to make sure you don’t have avoidance moves turned on.

[Hash2006]

Ok thanks!!!

[Douglas]

a move point can be inside a feature, double check for that

[SingularitY]

Can you post some code?

[Hash2006]

What Code?

[neil.challinor]

Can you post the edit window code (your program) so that we can see the commands? Ideally, put the edit window into command mode and fully expand all of the commands first.

[Hash2006]

Sorry, maybe I wasn't explicit enough, I run the same program 5, 6 times and I have no problem, and suddenly at the end of the program the head cmm produce a collision with the The part measured.

[SingularitY]

Posting code will still help here. It's hard to diagnose a problem like this without it.

[DHARTNESS55]

please print out the code and post it!

[BIGWIG7]

Put a hard stop/breakpoint at the end of the program.

[Schrocknroll]

When you run it the next time it runs fine?