Tweet
I am trying to do a line scan and I can't click any points on the model for my start, direction and stop. I could click on model to get all my points for alignment, but not for scanning. What am I doing wrong?
-
Hi guys, working through the manual on scanning and cant seem to work around my problem. I have the hexagon block for cad model and i have the block itself...06-07-2012, 08:57 AM -
Good Morning Everyone,
I want to preface this with the fact that I am new to PCDMIS and Metrology so I apologize if I am a little green....09-05-2017, 11:32 AM -
Good Day Gents,
I am having an issue with scanning.
When I try to create linear open scan and I execute... it hits the part as points. ...03-10-2016, 01:03 AM -
Hi Folks....Here is my problem:
We are trying to check the outside contour of a part using the cad model. It is an irregular contour shaped...01-05-2008, 08:50 AM -
Hi Techs:
I am working offline in 4.1, and have a quick question.
I am doing linear closed scans to a customer supplied...12-12-2012, 07:34 AM
Comment