Tigo SF Fixed Scanning head. All of a sudden, probe takes 1 hit on cal sphere and errors out saying check your hardware config or replace hardware. After several attempts, it will take 3 hits and on the 4 hit, it will retract very slowly and then error out. It also gets stuck in on of the probe holders on the rack. Already submitted a ticket. Waiting on a friday afternoon now. :\
Cannot Calibrate Probes
Collapse
X
-
Update, the teamviewed in this morning and took an error log from the FDC. They think that it could be a module in the controller or the head itself. It due for its first annual calibration in a few weeks so i'm glad its still under warranty. Machine homes like normal. They ruled out the PC or Pc-Dmis itself being the problem. Waiting to see if they'll send a tech soon.
Comment
Related Topics
Collapse
-
by mdaviesI am new to the PC DMIS software and when we recalibrate tips we do all positions due to moving the sphere. Is this required or is there a way to recalibrate...
-
Channel: PC-DMIS for CMMs
12-12-2007, 03:22 PM -
-
by SAR4UGood morning all!
Here is a description of what I am working with.
Its a 2012 OPTIV Classic vision cmm with tp20 touch probes with...-
Channel: PC-DMIS Vision
04-12-2019, 01:04 PM -
-
While calibrating probes, two of the probes in my 6 station rack went to find the sphere approximately two feet from where the sphere is actually located....
-
Channel: PC-DMIS for CMMs
05-09-2013, 03:28 PM -
-
by BIGWIG7big program that requires 3-4 (more or less) different probe builds and tips.
calibrate all the probes only to find out half way through...-
Channel: PC-DMIS for CMMs
04-13-2015, 05:54 PM -
-
I have a Brown and sharp Image with a probe rack. normally I am able to calibrate the entire rack and the do a probe to probe verification to make sure...
-
Channel: PC-DMIS for CMMs
06-29-2018, 03:11 PM -
Comment