not sure what is going on....

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    not sure what is going on....

    The theo. are dead nuts to the print... but then the actuals are off by .02 in X and .up to .04 in Z. I am struggling trying to figure out why this is. If the theo. are correct and the actual part is correct then why would it be going to a completely different spot to probe? It sits flat with no moving.
    Back story is.... we just got a new probe... the probe was just calibrated. We went from a scanning head to a reg. Any ideas??
    Tags: None
  • #2
    machine drift, turn SNAP=ON, Pcdmis removes machine drift.
    sigpic
    Originally posted by AndersI
    I've got one from September 2006 (bug ticket) which has finally been fixed in 2013.
    • Likes 1

    Comment

    • JEFMAN
      #2.1
      JEFMAN commented
      10-01-2019, 10:10 AM
      Editing a comment
      It's just a way to make those who know nothing about it believe that the machine is perfect !
Previous template Next

Related Topics

Collapse
Working...
X