Hello everybody I am in a pickle so I have this part and they're using 4 points for the A datums on a cylinder at 45 degrees from the center on a 1.380 dia. And 2 point for B and i point for c 20190911_180853~2.jpg
Casting datum alignment help
Collapse
X
Related Topics
Collapse
-
by Msouth91Hello everybody I am in a pickle so I have this part and they're using 4 points for the A datums on a cylinder at 45 degrees from the center on a 1.380...
-
Channel: PC-DMIS for CMMs
09-11-2019, 10:10 PM -
-
by pernillaHi.
I've been reading in ISO 5459:2011 about datums and datum systems. It's very informative but somehow leaves me with more questions than...-
Channel: PC-DMIS for CMMs
05-27-2020, 07:22 AM -
-
by ALousyUserThis isn't a troubleshooting post, but rather a post that pries the brains of some here to help me accurately interpret Datum A of this print (see screenshots...
-
Channel: PC-DMIS for CMMs
10-14-2020, 03:24 PM -
-
by qcfire65What would be the correct way to measure the 0.3mm MAX for the "C" nets being that they are within the alignment? I can basically get different...
-
Channel: PC-DMIS for CMMs
10-31-2020, 11:32 AM -
Comment