PC-DMIS Machine Error

  • Filter
  • Time
  • Show
Clear All
new posts

  • PC-DMIS Machine Error

    Hello, first time poster. I've only been using PC-DMIS for about 6 months now. I'm getting a machine error "ERROR AI, S%1, TR_AI, 0x15006015 PHM datum error during movement". Any clues on what this could be? Any feedback would be greatly appreciated.

  • #2
    Maybe https://www.renishaw.com/cmmsupport/...m-error--17194 can give some indication (although it is titled "PH10 datum error").
    SW support - Hexagon Metrology Nordic AB


    • #3
      From what AndersI 's link describes, it's an error while the probe head module (PHM) is rotating the probe to a designated angle. If all the listed symptoms/contributors on that link have been pursued (too heavy of a stylus tip, obstruction preventing probe roation, etc). your probe head module is wearing out. Return By Exchange RBE PH10MQ's are about $5200 through hexagon parts department. I'm sure if your head is a different p/n it will be similar in cost. Beats $12k for a new one.


      Related Topics