Tweet
Im using linear open scans to scan the profile of the blade Im working on, I realize I should be using blade but training has not yet been provided for that. The issue Im having is when Im dimensioning the scnas with Line profile 1) I need it to give me data with the tolerance on the report analysis showing how far out of tolerance it is. What its showing me is the deviation from nominal. the textual portion does give the deviation but I need to show on the analysis. 2) Will line profile>nominals tab> best fit algorithm show me the scans in relation to datums without best fitting it, I need it to show the drift of the airfoil as I move up the blade in section heights?
-
I have a new part that to get to all the surfaces of the called out profile I have to measure multiple scans (open linear scans w/SP25). if I select...04-05-2011, 11:00 AM
-
So I created two different scans (two individual areas of a "complex" surface) and out of those two scans I created a single "compound"...02-05-2019, 05:56 AM -
I have a profile question that I'm trying to get my head around. In the image below is a picture of a gage that I'm trying to get the profile for the...10-15-2013, 12:39 PM
-
i have a dovetail feature that i am scanning as though it was on a comparator. there are ten seperate planar areas on this dovetail with ten seperate...08-21-2012, 02:48 PM
-
Some help please. I have done two linear open scans on a small airfoil. One on the concave side of vane and another similarly placed scan on convex....07-14-2008, 07:56 PM