Tweet
I have a slot that is .256 wide. My prehit and retract is set for .100. when the probe retracts it hits the opposite side of part. It is retracting more then the .100. What I'm I missing. Is there any setting that would cause this.
-
-
whats the diameter of your probe? do you have avoidance moves on?sigpic -
are you talking about touching the part manually or during DCC measurement? Keep in mind...
PREHIT/RETRACT
and
MANHITRETRACT
are two different settings.
so if you're experiencing this while manually jogging the machine, check your manhitretract setting.Ex-HexComment
-
It was the avoidance move it was set for .393. I didn't see it turned on. Thanks.Comment
-
Yeah, I forget about them too.Darroll
2018R2Comment
-
I see the how typical prehit/retract settings can be passed through .bas files. However, I seem to be unable to find how prehit and retract values are...06-25-2021, 01:07 PM -
Hi,
I am using a Hexagon 4.5.4 SF. I am measuring a small slot and the safe retract setting is such that I cannot get the probe into the slot in...03-07-2013, 04:02 PM -
The last few programs i have written are doing funny things after measuring each feature.
The probe approaches the part, the backs off...05-16-2014, 10:00 PM -
I had a windows XP PC (running v4.2MR1) on our Sheffield Endeavor 9.9.7 (PH10MQ, TP200) and the PC died back in July. So, I got a Windows 7 box and...12-14-2018, 03:06 PM
-
Some tight spaces on a family of new parts. We're using a .3mm X 50mm. Is there a minimum prehit/retract?? I couldn't find this info anywhere. And if...06-24-2015, 06:08 PM
Comment