Tweet
I am using an older version of PC-Dmis and am trying to get a report for the profile of a surface. I measured the first surface as a plane and leveled to it. the second plane is parallel to it 2.603" above. Parallelism, flatness, and dimension are all within .0002", but when I ask for the results of plane 2 in surface profile I get .009". Am I going about it wrong? I thought I should get similar results as flatness.
-
Somewhat confused today, but it is Monday...
I am setting up a plastic part that the customer has established a profile call-out for the...02-07-2022, 01:51 PM -
I am trying to check flatness and profile on a surface that is approx. 3" by 6". Is there a way I can scan it to give a good distribution of...06-22-2011, 02:33 PM
-
I have a print calling out Profile of a Surface with no Datum on a plane). I have always considered this basically a Flatness callout. I noticed today...02-12-2019, 08:52 AM
-
I have a part with a segmented surface that calls out profile of a surface (see attached). I take several points on each surface and construct a plane...09-18-2009, 08:25 AM
-
Profile of a surface per unit is allowed per a note in the standard. Can Geotol do this? I know per unit of a line works fine but I am measuring a complex...09-08-2022, 11:39 AM
Comment