Scans and graphics display issue.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Scans and graphics display issue.

    I know this has been covered before but tired of searching.
    When I run a program offline that has been ran and saved on the CMM all of the graphics (arrows) are huge. They do not snap back to the CAD model. I have to redefine the scan and the profile output for all scans.

    I have tried to go to (Operation/features/reset measured values to nominal/all) then run offline same thing huge arrows.

    At one time someone posted how to get them to snap to the Model and it worked that was when I was running 2016.1
    Does anyone know where this is. Is it in the settings editor if so where.
    Time for the Trolls to leave.

Related Topics

Collapse

Working...
X