Tweet
I need to construct a line from the center of a circle to its tangent. I forgot how I did this before. I know its simple. Thank you in advance.
-
Darroll
2018R2 -
Perp to the tangent through te center ? -
Drop point to the tangent line, then line between circle and drop pointComment
-
Both methods will work (same result), but JEFMAN's is one command and RandomJerk's is two, so I would prefer JEFMAN's...AndersI
SW support - Hexagon Metrology Nordic ABComment
-
Hello,
I am new to PCDIMIS and I am having an issue constructing a point from a line and circle intersection. I am using a generic...06-02-2022, 04:32 PM -
When dimensioning the distance between a line and a circle I am getting 2 different answers. If I do line to circle it is 6.2 mm longer than if I do...02-22-2007, 09:12 AM -
OK Guys,
I don't know how to do this. I've never done it before - hold the jokes please.
I've created a 10inch diameter...10-17-2006, 03:05 PM -
I have need to construct a tangent point of circle and line. I don't see a way to do this in PC DMIS (3.73 CAD). Any ideas?06-29-2007, 01:32 PM
-
I am trying to create an intersection point using a line and a circle. (line 2 & circle 2 I am using the method below. The point is not even close...06-26-2017, 05:14 PM
Comment