mirrored programs 4.1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mirrored programs 4.1

    4.1

    I have mirrored a few programs (left and right parts)

    What I have found is that if I have a line/edge that I probe manually, the program "mirrors" just fine.

    If I mirror a program that has "auto features / lines", the depth is incorrect. I have to go through the program and change the depth values from positive to negative or vise versa.

    Anyone else seen this or have a fix for it?

    thanks
    bob
    Which one gets ridden today? MPH vs MPG..tough choice, both are FUN
    sigpic

    Starrett RGDC 4028-24 :alien:
    Demon vintages 3.7, 4.1, 4.2, 4.3, 2009

Related Topics

Collapse

  • calbritton
    4.1 Rc
    by calbritton
    Has anyone upgraded from 4.1 to 4.1 RC. What are your thoughts / experiences with 4.1 RC?
    05-09-2007, 10:29 AM
  • GEllsworth
    Pc-DMIS 4.1 re-load issue
    by GEllsworth
    We had a computer hard drive crash, when we re-loaded 4.1 programs are running extremely slower. Programs say to run at 70% but it is actually running...
    02-18-2008, 06:52 PM
  • Randy L.
    4.1 is it worth loading?
    by Randy L.
    I haven't had much time to spend on this forum lately. I was wondering is it worth loading 4.1? I'm currently using 3.5 mr2. What are the main concerns...
    11-01-2006, 12:39 PM
  • Jim Poehler
    Mirror Programs
    by Jim Poehler
    Good day all. New problem here for me. It's been many years since I've used mirroring to create a left hand part from a right hand one. I use read...
    10-16-2017, 07:52 AM
  • Aguayo
    Mirror Program
    by Aguayo
    Ok I created a program for a right side on a part.I difined my out-put nominal
    dimensions to be print out.Now when I mirrored this program to create...
    04-19-2006, 07:23 PM
Working...
X