Fine Tuning of Alignments

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fine Tuning of Alignments

    Does anyone know if this feature does anything during execution of a program. The help file just says it adjusts the machinetopart transformation if you say NO to the update commands below question when changing an alignment, but I'm wondering if it does anything else. I'm trying to figure out why pc-dmis keeps changing nominals and targets for some lines and high points that are taken several times after rotation 45 degrees. It happens sometimes during execution of the program and always if I make any change to any alignments or any features nominals - even ones that have nothing to do with these particular points.

    It would be nice if you could compile the program, or something along those lines, when you're done with it so things like this couldn't happen. Or how about a text mode where you can type stuff in without it trying to do the math.
    Last edited by phil george; 03-06-2007, 03:36 PM.

  • #2


    Is this what you are asking about?
    Last edited by John Riggins; 08-16-2007, 07:27 PM.
    Lately, it occurs to me
    What a long, strange trip it's been.

    2017 R1 (Offline programming)

    Comment


    • #3
      Yes, that's it. Sorry I wasn't clearer.

      Comment


      • #4
        I have all of our machines set up with this option NOT checked.
        I have found that if it is checked you canot do "what-if" changes to your alignments.
        Lately, it occurs to me
        What a long, strange trip it's been.

        2017 R1 (Offline programming)

        Comment

        Related Topics

        Collapse

        Working...
        X