Linear Open Scan

  • Filter
  • Time
  • Show
Clear All
new posts

  • Linear Open Scan

    image_11923.jpg Good Morning you lovely people
    I am trying to scan the profile of this gear but i can't seem to get it to finish where i am telling it to! it finishes nowhere near my end point. Any ideas as to why this might be?
    I am running PC-DMIS 2016.0 with a SP25M/SM25-2/SH25-2 Probe head configuration.
    Last edited by Samsdadmatt; 12-02-2016, 09:41 AM.

  • #2
    On the execution tab, try upping the number of crossings and see if that helps. I have seen that happen when this value is too low, it may take a little bit of tinkering around to make it work.
    Last edited by bigtallanddopey; 12-06-2016, 02:58 AM.


    • Samsdadmatt
      Samsdadmatt commented
      Editing a comment
      That worked a treat
      Thank you very much!

    • KIRBSTER269
      KIRBSTER269 commented
      Editing a comment
      change your Font big, some of us are old and cant see so good

    • bigtallanddopey
      bigtallanddopey commented
      Editing a comment
      It keeps changing for some reason, forgot to change it this time

Related Topics