MM II or III "Burn Failed" message

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • MM II or III "Burn Failed" message

    Help please.....

    Anyone ever get a message of "Burn Failed" ???

    This is a B&S Microval with MM II or III

    Looks like it may be time to upgrade.....

    Any thoughts on what to upgrade to?

    We want to keep this CMM as simple as possible so the shop guys can use it for basic measurements on their own.
    Which one gets ridden today? MPH vs MPG..tough choice, both are FUN
    sigpic

    Starrett RGDC 4028-24 :alien:
    Demon vintages 3.7, 4.1, 4.2, 4.3, 2009

  • #2
    Did you contact B&S tech support? If I remember this controller contained EEPROMs to burn the volcomp info. You do not mention what you are doing when this message occurred.

    Comment


    • #3
      The display was showing "funny" numbers, so we re-booted the contoller. When doing the initial set up is when we see this error.

      The controller box has this cover on one side that has this "plug-in" module.
      I have re-set this module and now the error has gone away.

      Looks like we can put off the upgrade for a bit longer.

      The module has "MM II+" marked on it.
      Which one gets ridden today? MPH vs MPG..tough choice, both are FUN
      sigpic

      Starrett RGDC 4028-24 :alien:
      Demon vintages 3.7, 4.1, 4.2, 4.3, 2009

      Comment

      Loading...
      Working...
      X