Tweet
When i change my workplane it does not show up in my program also when i hit print after i move to a location the x,y,z does not show up in my program. Any sugestions.
-
-
Save your program, close the program and re-open it. I bet you will have your workplane and move point commands then.
Don't know why. Sometimes it does this. -
what version are you using, since we switched to to 3.7mr3 that doesnt happen anymore, before that we lost all kinds of commands only for them to reappear when the program was reopenedComment
-
How are you doing this?
Originally posted by rringer123 View Post
What exactly are you using to change workplanes? Please do not take this the wrong way, but are you just rotating the model on the screen? What is shown in the toolbar list? Does thw workplane change there?Comment
-
I tried to create a program in Y- workplane, it would not work. It looks good at first in the screen but when I ran it, thenfeatures are all
Screwd...08-09-2014, 08:54 PM -
Can't seem to find where to change the workplane color in the edit window. Have found most of the others. Maybe its in front of my face. Anyone change...12-10-2009, 08:21 AM
-
If you have a part ,that have a circle in a different workplane (in Xplus for example )and you use autocircle , do you need to change the workplane manually...04-22-2009, 08:26 AM
-
When measuring a circle in manual mode using measure circle instead of measured guess ,pc-dmis will write a workplane shift usually X-Plus into the program...01-27-2011, 11:37 AM
-
I have been using PC-DMIS since 2010 on a Helmel Microstar with a Renishaw MH8 head and a TP2 probe. Just in the last week I have started to have a problem....06-16-2014, 02:55 PM
Comment