I'm scannin free-form surface with SP25 probe, with step 0.1x0.1 mm. Theoretical I should obtain 1.000.000 points. When pc-dmis create scanning line appear message "Max line attainable". That is to say this message??
"Max line attainable"
Collapse
X
Related Topics
Collapse
-
by TestedI'm trying to construct a line perpendicular to a already created line thru a point.
LIN40 =FEAT/LINE,RECT,UNBND
...-
Channel: PC-DMIS for CMMs
08-02-2006, 07:42 AM -
-
by LebrocHi everyone,
That's the first time i come on this forum. I have not a large experience in CMM.
I am trying to make measurements...-
Channel: PC-DMIS for CMMs
03-03-2016, 05:38 AM -
-
by SAguyHi everyone,
I'm new to the forums and DMIS in general. So far I seem to have everything down good except for this one nagging issue:...-
Channel: PC-DMIS Portable
03-31-2011, 03:13 PM -
-
by dirkoI am trying to CONSTRUCT 2 lines. One that is parallel with line 4, .140" to the left. And one that is parallel with line 3, .140" to the...
-
Channel: PC-DMIS for CMMs
09-06-2013, 03:09 PM -
-
by djsnyderNovice here ... I need to establish a line 37.5 degrees from a center line and then measure the distance from that newly established line to a wall in...
-
Channel: PC-DMIS for CMMs
01-28-2009, 12:28 PM -
Comment