Hi everybody.
I did adding probe angle many times, it worked fine. Today, I add A90B-172, then calibrate all tips as usual, but probe A90B-172 was off center of sphere. I could not figure out of this issue ( already check mark on Defined probe box).
Could any expert instruct me how to do with this ?
Thanks
I did adding probe angle many times, it worked fine. Today, I add A90B-172, then calibrate all tips as usual, but probe A90B-172 was off center of sphere. I could not figure out of this issue ( already check mark on Defined probe box).
Could any expert instruct me how to do with this ?
Thanks
Comment