Move Point Relearn

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Move Point Relearn

    When I input a move point relearn, and it comes up in the program to move probe to the new location and hit ok......I can't move my machine. It's like its locked because it's in the middle of a program. Any suggestions?
    ~Josh~ Giles Rescue "Ut ceteri vivant"

  • #2
    Will it let you move if you hit ALT-X on the keyboard?
    sigpic
    Originally posted by AndersI
    I've got one from September 2006 (bug ticket) which has finally been fixed in 2013.

    Comment


    • #3
      I'll give that a shot in a bit.....Thanks!
      ~Josh~ Giles Rescue "Ut ceteri vivant"

      Comment


      • #4
        ALT+X should put the machine into manual mode, when it is running in DCC and ALT+Z should put it back into DCC after you do an ALT-X. All this is while it is running (executing) in DCC mode.
        sigpic
        Originally posted by AndersI
        I've got one from September 2006 (bug ticket) which has finally been fixed in 2013.

        Comment


        • #5
          Originally posted by Matthew D. Hoedeman View Post
          ALT+X should put the machine into manual mode, when it is running in DCC and ALT+Z should put it back into DCC after you do an ALT-X. All this is while it is running (executing) in DCC mode.
          Matt,

          It will not let me hit ALT+X or ALT+Z with this message on the screen to move to new location....
          ~Josh~ Giles Rescue "Ut ceteri vivant"

          Comment

          Related Topics

          Collapse

          Working...
          X