Scan Type

  • Filter
  • Time
  • Show
Clear All
new posts

  • Scan Type

    Just wondering if I could get some scanning help.....Check out the pic. i am trying to do a scan around that highlighted area. I got it setup as a perimeter scan, but, I don't want it to go into the corners due to a very large radius in each corner. So, how do I tell it to stop and come back the other way before it gets in the corner?

    Another way I tried it was with the patch scan. But, for some reason, I can't get it to do the whole thing at once. I had to do it in three different sections.
    Last edited by jkb_mcg; 08-16-2007, 04:42 PM.
    ~Josh~ Giles Rescue "Ut ceteri vivant"

  • #2
    There is an area for offset, that will offset it whatever amount you type in from the CAD highlighted edge.

    James Mannes


    Related Topics