Tweet
I have not used many disk probes. I calibrated a 25mm dia X 3mm With 12 hits and start angle of 10 end angle of-10 i got good calibration results but is this right ?? ohh 3levels but it only did the above the equator and below the equator of my calibration sphere. not on the equator?? should it have.
-
Hi All
I am looking for a little feedback (HELP) on how to measure the spline I.D. datum B and the other feature, was thinking of using...03-31-2006, 03:49 PM -
Is there any precautions or procedures to follow when calibrating a disk probe? The probe is defined correctly in the pull down menu. Will PC-DMIS recognize...06-03-2008, 03:03 PM
-
I have been trying to use my ruby disc probe but i can not get any of the dia. or runouts to come out correctly. I calibrated it manually like it says...11-11-2009, 11:07 AM
-
Does anyone have a documented procedure for calibrating disk probes? The PCDMIS procedure does not work for me for some reason. It is 18mm in dia. and...04-22-2008, 05:22 PM
-
I have a B&S global I can calibrate the sphere and the get my disc probe then after it takes its first hit in DCC the drives kick off. I have done...04-11-2016, 05:33 PM
Comment