Arm2 Calibration Error

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Matthew D. Hoedeman
    replied
    SWEET!

    Leave a comment:


  • bob mappes
    replied
    Arm 2 window shows up in 4.1 also

    Leave a comment:


  • kevinb
    replied
    Do not provoke arm 2! Do not look at arm 2 directly! It might perceive a threat and hold your hard drive hostage!

    Honestly, Matt's right. If you let it finish calibrating and then close the program and PC-DMIS normally everything is fine. If you try to cancel calibration or something like that, PC-DMIS conveniently crashes, erasing any changes you made without saving. Yes I speak from personal experience.

    Leave a comment:


  • TigerShark
    replied
    Originally posted by Matthew D. Hoedeman View Post
    Nope, you can't get rid of it short of closing Pcdmis entirely and re-opening. Just one of the MANY 'enhancements' added by Wilcox and company.
    YES, you are Right

    Leave a comment:


  • Matthew D. Hoedeman
    replied
    Nope, you can't get rid of it short of closing Pcdmis entirely and re-opening. Just one of the MANY 'enhancements' added by Wilcox and company.

    Leave a comment:


  • TigerShark
    replied
    Originally posted by Matthew D. Hoedeman View Post
    Just finish the calibration, then close out of everything normally, do not cancel or quit. Finish the calibration, close the cal window, close the program, exit Pcdmis, start it back up. I have had that little window pop up a few times, just ignore it, but leave Pcdmis in a normal manner and it will not cause a problem.
    Thanx for reply, any way you are closing and opening again, I meant is there any solution that totaly fix this issue? I have ignored this window but it does not goes away, when evry thing is calibrated, it is showing on the TOP, even when I close the program, it shows up on PCDMIS LOGO ( Base).

    Leave a comment:


  • Matthew D. Hoedeman
    replied
    Just finish the calibration, then close out of everything normally, do not cancel or quit. Finish the calibration, close the cal window, close the program, exit Pcdmis, start it back up. I have had that little window pop up a few times, just ignore it, but leave Pcdmis in a normal manner and it will not cause a problem.

    Leave a comment:


  • TigerShark
    started a topic Arm2 Calibration Error

    Arm2 Calibration Error

    I am using 3.7 MR3 , It is linked to a Mitutoyo GATE CMM , Some times when I calibrated the Tip, two windows will shows up ( instead of One), second windows title is " Arm2 ", but I do not have any second Arm.

    If I cancel this issue all software will jumps out and close and I have to start PC-DMIS again. Any body knows about this? any soultion is Highly appreciated.

    THANK you

    Shark

Related Topics

Collapse

Working...
X