Tweet
Brain fart. I cant remember how to get tolerance bands to show up in the graphics!!
-
I would like to report a point location without a tolerance associated to it. How do I go about this? The only option I can see is the "locate...07-30-2008, 10:42 AM -
Hi guys, may you help me a little? How to change tolerance to show me both in + or both in - ; default is example : some nominal of hex is 33.5 and...04-15-2009, 11:07 AM
-
I would like to know how to show the points take on a feature. It looks like a wire frame in 2D but shows the points as a in/out tolerance condition.09-10-2018, 02:51 PM
-
Hey guys!
After a short delay, I am back amongst the truly intelligent. After being over worked and under paid (11 bucks an hour), I finally...02-25-2014, 11:15 AM -
Why does the o.o.t. block show 1 when there is no red on the report.I am dimensioning a profile of a surface of a scan with form and location, with a...09-08-2016, 03:10 PM
Comment