Converting PC-DMIS to Geomeasure

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
    No photos found.

Related Topics

Collapse

  • dwade
    Dilemma with datums
    by dwade
    What I have run into while looking into correlation issues with a customer is datum feature measurement. The parts were programmed with CAD (and using...
    06-04-2014, 03:13 PM
  • emurray
    Please take a look
    by emurray
    I am running a pre-existing program for one of our parts. The problem I am having (this time) is after I am prompted to take my manual measurments,...
    08-14-2007, 01:32 PM
  • Aguayo
    Program from Renishaw
    by Aguayo
    Please take a look this the program below,renishaw sent it to me yesterday.I
    ran it,but I did not get the results the file was emthy,renishaw said...
    05-10-2006, 09:03 AM
  • j.gonzalez
    accuarcy of a circle
    by j.gonzalez
    i got a 4 circles all measured the same tolerences are .9449/.9454 the cmm is kicking it out at .9456 i manually check the part using an air gage it's...
    06-23-2009, 12:42 PM
  • Ken379128
    Nominals changing
    by Ken379128
    Why when I run thru a program do my nominals keep changing. I go in put them to what I want and when it runs it changes it right back????...
    02-03-2007, 11:29 AM
Working...
X