mmIV help-Angles

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mmIV help-Angles

    Can anyone help with mmIV Angle measurement? I'm
    trying to find 20 degree Circle to Line angle.
    (I was real comfortable with PCDMIS 3.7 at my other job, the placed closed and I got a job here using mmIV, which I was had never programmed before.)
    Any advice would be really appreciated.

  • #2
    Have not used MMIV for quite awhile but if I remember it works in blocks or chunks sort of like the summary on PCDmis. If you dislike that then menu close to title bar will give same commands (will have drop downs) but a bit more flexible. Get familiar with that - Sorry can't assist more...

    Good Luck.

    JRZ

    The difficult we do now. The impossible will take a little longer.
    PC-DMIS CAD++ 3.7 from 4.2 MR1

    Comment


    • #3
      Thanks Joe
      I did find some info in the 10 year old users manual under Measurement Routines: Line/Axis Angle. Calculates the angle between a 2D line and the major axis. Getting good readings!
      Know I need to find info on profile.
      Thanks again for your input

      Comment


      • #4
        No Problem Jim - i wished could have helped more but it's been a long time since i worked on mmiv - it wasn't too bad of a software, just take getting used to.

        Good Luck in your new job - hope it works out.

        JRZ
        PC-DMIS CAD++ 3.7 from 4.2 MR1

        Comment

        Related Topics

        Collapse

        Working...
        X