Xaxis encoder replacement

  • Filter
  • Time
  • Show
Clear All
new posts

  • Xaxis encoder replacement

    Is it possible to replace my 9-15-9 B&S Xcel Xaxis encoder with the encoder from my B&S Xcel 7-10-7.
    If so, what kind of settings might have to be adjusted.

  • #2
    If it's the same model, you can change, but you will need to set sinus and cosinus readings with a scope...


    Related Topics


    • dwade
      by dwade
      I've got a MicroVal PFx 4-5-4 running 3.7mr1 and the operators ran into an error message last nite. "TR_GEB_Y.ERROR AT ENCODER SIGNAL Y-AXIS"...
      07-10-2006, 08:17 AM
    • brace74
      Problem with encoder Y signal
      by brace74
      I am having problems with a CMM Global Status 544. When I try to move it in a Y axis is showing me a message with the legend:"TR_GEB_Y, Error at...
      01-03-2007, 07:04 PM
    • kamil
      B&s microval 303 - encoder problem
      by kamil

      i have a b&s micro val that had a encoder damaged. So i have exchanged it for a new one. However, it wouldn't work, so i have changed...
      09-03-2009, 03:34 PM
    • Ceeph
      by Ceeph
      I am running a B&S XCEL 9-12-9 and receiving an X-axis chip rate error. I cleaned the machine. Is there anything else I can try before calling...
      05-08-2007, 11:59 AM
    • Hardrive
      Repair possibilty?
      by Hardrive
      Afternoon Gents,
      Got a Dcc Gage ( 18x20x16 ) with a foul y axis encoder. I can get the part no problem. I have the panel off covering the encoder...
      06-29-2006, 04:19 PM