Tweet
When i print out the results of a boxed dimension i enter the +tol and -tol as zero, but the MAX and MIN still print out and sometimes show out of tol. Is there a way to turn these off? i am running MR2 V5.01.
-
V 3.5 MR2
my print outs have the results from the AutoCalibrate of the probe. I was wondering if this could be turned off?
...10-02-2007, 01:34 PM -
Hello Everyone;
In the PC-DMIS VER 3.7 Release2 sample print out below.
I have what looks like a simple problem and I did...09-28-2006, 09:35 AM -
I was on FMLA for the birth of my new son, and when I came back, one of themachines prints reports with alignment info at the top of the page! I have...03-07-2006, 08:39 AM
-
Hello Everyone;
In the PC-DMIS VER 3.7 Release2 sample print out below.
I have what looks like a simple problem and I did...09-28-2006, 10:04 AM -
I measured perpendicularity of two surfaces, one a top surface and the other side surface,
this is the results,
DIM BOTT.SLOT1...01-04-2016, 02:42 PM
Comment