constucting circles on scan lines

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tested
    replied
    Can you define what you mean by a "irregular cone"?
    Maybe post the CAD if you have it.

    Leave a comment:


  • dwade
    replied
    Originally posted by John Kingston View Post
    Can you construct a cone from the lines? You then can construct a diameter from the cone at the heights you need.
    I use this method often and it works good. IWe have a part and the CMM will match the air gage the company spent thousands of $$ on within a tenth or two.

    Leave a comment:


  • Underspec
    replied
    Use the "To Points" feature of the scan and make sure you start at the same depth on up. Your points should be level to eachother then change the workplane to what you need to construct the circles.

    Leave a comment:


  • John Kingston
    replied
    Can you construct a cone from the lines? You then can construct a diameter from the cone at the heights you need.

    Leave a comment:


  • kyle lattenhauer
    started a topic constucting circles on scan lines

    constucting circles on scan lines

    I have a part that looke something like an irregular cone. I have scanned up the sides of the part in 3 spots and I need to constuct circles at increments about ever .005 over a 1 inch section. The probelm i am having is creating the circles. I can not even seem to creat points on the scan segments in the areas i am expecting. Am i doing someting wrong?

Related Topics

Collapse

Working...
X