Tweet
I have used metafiles in reports before; no biggie. (Usually I just do a picture of the CAD model.)
I have now been asked to add the graphical display of reported dimensions on measured features. My problem is that these data boxes come out waaaayyyyy too small in the report to see the numbers. I know that I'll have to break the CAD model into 3 or 4 different pictures to get this data to display. Some of my parts are around 32-38 inches long.
Is there a way to up scale, increase the size, of the whole metafile 'picture' shown in the printed report? Right now, the metafile only covers about 2/3 of the width of the paper.
I have now been asked to add the graphical display of reported dimensions on measured features. My problem is that these data boxes come out waaaayyyyy too small in the report to see the numbers. I know that I'll have to break the CAD model into 3 or 4 different pictures to get this data to display. Some of my parts are around 32-38 inches long.
Is there a way to up scale, increase the size, of the whole metafile 'picture' shown in the printed report? Right now, the metafile only covers about 2/3 of the width of the paper.
Comment