Hi Everyone.
Pc Dmis 4.0..
If You make a plane, level and set Z origin to that plane..
Take a single point for a Z dim.. Either plus or minus.
The measurment always comes out ZERO...
Anyone else have this problem???
The only way to get a Z reading is using distance between, or make it a plane instead of a single point.
This amazes me!
Would love to see if anyone else has this happen.
Take care..
Len
-
Heres my problem. The part I'm working on has a flat machined surface, it 12x12 inch's. Theres cores about every 2.5 inches around the edge's all the...03-02-2007, 08:59 AM -
I constructed a high point plane from 32 hits. 8 hits are higher than the plane. I calculated a tangent plane with Excel that give better results...
...
02-20-2013, 06:00 AM -
Why is there a difference in the way PCd calculates the distance from a plane to a point? Shouldn't a 2D distance from point to plane perpendicular to...12-01-2009, 04:50 PM
-
Can you please tell me how High Point Plane works? I mean what happened behind the command when we select several points and use this Plane construction?...10-11-2007, 09:39 AM
-
Hi,
I was wondering if anyone could tell me how PC-DMIS views a plane to plane dimension. What my boss would like to know is when you level and...10-24-2008, 12:14 PM