I have been running 4.0 for about 3 weeks with no real problems. Today I opened a part the had run before, and it had this error.
Serializtion...
-
08-10-2006, 12:03 PM -
I'm taking manual hits on 2 OD's after my manual alignment, because these 2 features are tie rod ends and may change position from part to part. I use...01-17-2009, 03:28 PM
-
See attached PDF.
I just pulled up a program I made a few weeks ago. I have to run a few parts through this program to complete...02-06-2014, 11:36 AM -
Is any one else having this problem?
I cant even run programs I have previously run with no problems.
This started after switching to 4.2...04-16-2008, 01:41 PM -
Was wondering if anyone has had this problem...My report says nominal, +tolerance,-tolerance, deviation, and out of tolerance.....when measurement is...03-11-2008, 10:28 PM