Tolerance Zone error.

[Moore Racing]

Hi Everyone,

I'm having a problem running a part program.
Using Dmis 4.0.

I made a part program, part checks out nice..
When I run my second part, I get to a certain point in the program and it won't take points.
I get an error "point taken outside Tolerance zone. Distance = 10

(I'm thinking there is a setting for the distance equals?)

The part has an alignment and it is basically in the same spot as the first piece used to create the program.

I had this problem before.

This is a manual B&S gage 2000.

Thanks for the help.

Sincerely
Len

[Paul Sarrach]

I dont have 4.0. But is it stopping at a Dimension in the program? If so delete it out. It may be looking for something that is not there. I have seen this before.

[Jan d.]

I am using 4.0, but never have never seen this issue before. Sorry...

Jan.