I've done an itterative alignment off of three tooling balls, and constructed my alignment.
Next, I have measured three points on a boss face (Y vector), and constructed a plane. The boss face is on a compound angle, x & y directions.
What / how do I do to correctly call out the required angles.
(pcdmis ver3.7mr3).
Thanks in advance !!
ZydecoPete
Next, I have measured three points on a boss face (Y vector), and constructed a plane. The boss face is on a compound angle, x & y directions.
What / how do I do to correctly call out the required angles.
(pcdmis ver3.7mr3).
Thanks in advance !!
ZydecoPete
Comment