Tweet
I am new at working with tubing and was wondering if anyone could help me on how to do a best fit alignment on tubes.
-
-
what kind of tubing? and what are you aligning?I used to be high on life but I built up a tolerance.
Brown & Sharpe Global Advantage
PCDMIS CAD++ v2011mr2
PH10MQ/SP600M
sigpic -
Best Fit
Steel tubing with constructed points between cylinders and cylinders and planes with theo's already provided.Comment
-
Well the secret is in how you define your features. The single contructed points wont give you the best result. I would suggest an iterative alignment. So if corrections need to be made, the results can be repeated.sigpicComment
-
Hello Guys
I have been searching for best fit alignment topics but could find any with basic walktrought steps on how to perform it , i only...02-17-2020, 02:23 AM -
Hi Friends,
I am new to best fit alignment. I have attached a report from a CMM result which measured with best fit alignment. I roughly...02-24-2014, 05:13 PM -
Is anyone familiar on how to do a best fit alignment with constructed points on tubes ??09-05-2006, 11:44 AM -
Wondering what process to use for a best fit alignment. Using UG CAD model to check some small parts that are finish cut before heat treat. Performed...07-11-2006, 09:38 AM
-
Hello once again,
i have been searching for a week and for the first i feel unable to fulfill my greedy curiosity , i did understand several...02-19-2020, 08:46 PM
Comment