OPEN SLOT - NOTCH

[Jeffrey Lovely]

I cant seem to get this to work today
dont use it often enough
open slot, using cad ,what order do I pick
help file did not help enough
4 mm x 15

using 3.5 mr2

[tking]

I cant seem to get this to work today
dont use it often enough
open slot, using cad ,what order do I pick
help file did not help enough
4 mm x 15

using 3.5 mr2

With 3.7 mr3 there is an area at the lower left of the screen that will tell you what the demon is expecting you to do when picking the points.

TK

[Jeffrey Lovely]

What does it tell you to do?
I have 3.5 mr2
help file says 2 at the far end opposite of opening
then one on each of the sides
then one at the edge of opening(?)

[Jeffrey Lovely]

I got it to work
was not happy with the measurements
trim shows much better
noms did not com out correct
garbage in - garbage out