Tweet
I wrote a program yesterday and all seemed fine. I open it today and all I see are the manual alignment features. So I go into feature appearance and highlight all features and click apply and they all show up. I save it and reopen and theres only manual features again. What gives?
-
The Graphics display window always show feature ID such as I use DCPNT1 for vector point. I took from DCPNT40 to DCPNT121 on top surface to construct...05-10-2016, 03:36 PM -
I have a couple of problems. My first and most aggrivating is in my graphics display window I have lost view of my measured dimensions and feature ID's,...08-03-2007, 05:34 PM
-
Is there a setting that would allow only the currently measured features to show in the graphics window? I would like the graphics window to only display...01-14-2007, 03:03 PM
-
I keep losing my Graphics display when I execute my program- not always at first but somehow I change something ignorently and I get the demons...
10-15-2007, 08:47 AM -
Has anyone had this happen to them?
Programs were running normally, but now the graphics window is no longer visible (showing cad and where...05-18-2018, 08:48 AM
Comment