Tweet
I have surface profile points that were originally called out to -A- -B- -C- (established on the fixture) that have been changed to profile to a single feature - a hole on the part near the points. Would you best fit these points with the hole before reporting them out or just report them relative to the hole?
-
We have a part that is calling a Profile to be Datum A. The shape of this profile looks like a potato chip, so I believe this would covers all 6 degrees...10-14-2022, 09:21 AM -
Have a callout "Profile of .007 to A" and another "Profile of .016 to A & B"
How does one isolate only one or two datums...03-21-2007, 12:06 PM -
Hello Folks,
I have a typical part with datum "A" (level), "B" (origin), and "C" (rotation).
...10-11-2006, 01:53 PM -
I have a profile callout to a datum (hole). The problem is that I can't get the demon to report profile to a different alignment than what it was measured...07-11-2008, 09:16 AM
-
Hello All
I'm currently trying to understand the finer details of Profile measurements thanks to the lovely customer. The surfaces in question...12-22-2020, 11:56 AM
Comment