Hi just got a new computer and reloaded my 3.5. I need to change the size of the graphical ball after taking a measurement and forgot how to do this.
Ball Size
Collapse
X
-
Originally posted by Bill McCaffertyMisread that one.. Man have I been busy around here.
Remember John Kruk when he returned to MLB after surgery removing a cancerous testicle. " If you guys don't quit joking, I'll take my ball and go home...."When in doubt, post code. A second set of eyes might see something you missed.
sigpic
Comment
Related Topics
Collapse
-
by Budking21How do you run a program written with a 3mm ball tip with a 2mm ball tip, or any size at that matter? Can you just go in and change it at the beginn...
-
Channel: PC-DMIS for CMMs
07-28-2009, 11:09 AM -
-
by hobbieSorry for beating a dead horse, but this morning I went to cal my tp200 A0B0 and after the touch normal to probe. pc-dmiss took the standard three hits...
-
Channel: PC-DMIS for CMMs
04-14-2009, 01:48 PM -
-
by Richard RyerI am new to this forum and don't know if this topic has been discussed. I am measuring a XXX gage ring and the reported size is incorrect. Probe condition...
-
Channel: PC-DMIS for CMMs
06-12-2008, 10:07 AM -
-
by Nada_IncJust wondering if anyone has a list of the positions to preform during the ball bar check. I have a ball bar and the program just would like to know...
-
Channel: PC-DMIS for CMMs
11-13-2014, 11:22 AM -
-
by RayRonanHi All,
I have ran our probes through calibrated set rings at various sizes and found that the sizes (diameters) given by software is off...-
Channel: PC-DMIS for CMMs
04-23-2013, 07:51 AM -
Comment