Question about Alignment

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Question about Alignment

    We got a check fixture made to check both LH & RH . parts are same only different at the end trim angle,I got one set of tools ball coordinate ,it is for
    LH part, everything run ok with LH program , but when mirrored to RH
    I couldn't make it, the probe is under nieth of cad and program can not be excuted,
    please, how to mirror , in steps.

    Thanks
    Tags: None
  • #2
    Perhaps when choosing part to mirror, you selected "Mirror in Z" instead of "Y"?
    sigpicIt's corona time!
    737 Xcel Cad++ v2009MR1....SE HABLA ESPAÑOL

    Comment

    Previous template Next

    Related Topics

    Collapse
    • bsacmm
      mirroring cmm program??
      by bsacmm
      Using PCDMIS 4.2mr1.
      I have a rh and lh part sym opp. I would usually writhe the rh program and mirror it for the lh. However in this case the...
      11-16-2009, 11:50 AM
    • Nfisk
      Mirror, Mirror
      by Nfisk
      In our shop we are building two parts. One is a left hand part and the other is a right hand part. Essentially a mirror image of each other. I have...
      05-16-2008, 03:59 PM
    • RClone
      mirror headache
      by RClone
      3.7 MR2 I spent the day messing with the mirror command to get the left hand part programmed from the right hand part program.
      The help file...
      11-09-2007, 04:59 PM
    • jaymunday
      Mirror parts
      by jaymunday
      At my last job we had a program that was mirrored. Does anyone know how to do that.
      02-29-2012, 05:19 PM
    • shadowr2b
      Mirror Image Program
      by shadowr2b
      I'm trying to make a program of two parts which are exact mirrors of each other.
      I wrote a program for one but I would like an easy way to maybe...
      10-16-2015, 10:00 AM
    Working...
    X