Tangent for a line

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tangent for a line

    I need some help on the best way to construct a line.

    Ok what I have is 2 cresent shaped slots at the end of the slots are 4 radius

    The slots are of 2 different widths . I create a circle out of the 4 radius. That comes out good. The angles of the end of the 4 radii are 40deg and 17deg for each slot What would be the best method to egt the tangent of each radii.

    Would have been so much easier to just use the center of the radius.
    Thanks
    Tom
    sigpic
    if you had soap on a rope it would be tied to yer ankle

  • #2
    never had too much luck with trying to obtain tanget lines in pc-dmis.

    if you could post a pic, it would be easyer to visualize what you are decribing. maybe you could offset a line or something...

    Comment


    • #3
      pic of part

      Tangent2.JPG
      sigpic
      if you had soap on a rope it would be tied to yer ankle

      Comment

      Related Topics

      Collapse

      Working...
      X